Pay in 4 interest-free payments of $33.83 Learn more
Ships within 48 hours · Estimated delivery Aug 10 - Aug 15
Thinly spray the still wet vehicle and rinse thoroughly with water immediately
2% of an instantaneous temperature change Five time constants are required to approach 100% of the step change value
Use to connect CAN devices into Link CAN bus
as well as 160A of non-repetitive maximum current
joints are dropped
Link ECU Ballast Resistor (BAL6) Mitsubishi Thinly spray the still wetFor use with low impedance injectors. Compatible with injectors with impedance between 2 and 6 Ohms. Please contact us if you are planning on using injectors with an impedance of less than 2 ohms. Includes set of 6 x 4. 7ohm 25w resistors mounted to a heatsink. These are also sold in a set of 4. Note that injector ballast resistors get quite hot at high injector duty cycles. These should stay mounted on the supplied heat sink and be bolted to the
US$ 359.55
US$ 989.40
US$ 45.00
US$ 16.00