SpeedFactory Racing Titanium VTEC Eliminator Pin Kit for Honda H Series SF Parts these are manufactured using Ti-6AL-4V

these are manufactured using Ti-6AL-4V Titanium

You can also measure at the valve tip as below

- For our Race Radiator Hose and Fitting Kit

SpeedFactory 3 Bar MAP (Manifold Absolute Pressure) sensors use state of the art bipolar op amp circuitry with thin film resistor networks built into each micro chip

STi conversion fuel rails are used to convert the '04-'06 STi or '05-'06 Legacy GT fuel system from side feed injectors to top feed fuel injectors and as such use specific Fuel Injector Clinic injectors

SpeedFactory Racing Titanium VTEC Eliminator Pin Kit for Honda H Series SF Parts these are manufactured using Ti-6AL-4VSpeedFactory Racing Titanium VTEC Eliminator Pin Kit for Honda H Series These pin kits are designed to be used in drag race applications where the engine is operated at high RPM with limited idle low rpm use, not in a street car. 8 Pins for locking VTEC on all H Series VTEC engines Lightweight Titanium, 37% lighter than stock pins (8. 3g per rocker assembly) VTEC solenoid can be left in place, or a block off plate can be utilized LMA's can be left in